Essential Aspects About Kitchen Cabinets

You have the option, as I described above, to use a piece of 1′ x 3′ lumber to install or construct a frame to support the cabinets (I included a picture of a sample frame below). This can be made from 2 ‘x 4’s, and should be tall enough to support your wall cabinet bottom. If you are planning to install more than one kitchen, then I’d suggest the frame, but if this is a one-time event, a piece of lumber will do just fine. In any case, you’ll need a separate pair of hands to assist with the build.check this link right here now

We purchased (RTA) ready-to-assemble kitchen cabinets in this case from the RTA Kitchen & Bathroom Cabinet Shop. The kitchen cabinets are now being assembled; we are ready to begin marking out our layout lines. Most people start with the base cabinets but we will start first with the wall cabinets. There is no right or wrong way to get going, I ‘d rather just start with the upper cabinets first.

  1. For draw a parallel line across the wall about 3 inches up from the surface, use a level and a pencil. Measure down to the floor from this line, and locate the high point of the floors (if it has one), and mark a line at that level. Measure up to 34 1/2 inches from that high point and draw a straight line across the wall to mark the base cabinet tops.
  2. Now that the base cabinets are labelled at the top, measure about 19 1/2 inches and a straight line across the wall to show the wall cabinets at the bottom. To ensure that your original model is right, mark the dimensions and location of each cabinet gently on the wall.
  3. To locate the wall studs, use a stud-finder. Using a pencil to mark the positions of the studs at least 6 inches above and below the wall cabinet bottom line. Draw straight vertical lines between the top and bottom markings to show the studs centre.